Uromix

USES

SOLUTIONS FOR SURFACE CRACK LINE
- Crack line under the beam
- Crack line between concrete column and brick wall
- Crack line of 45º (diagonal) near the window or door

SOLUTIONS FOR RECURRENCE CRACK LINE
- Simplest and most economical way to remedial recurrence crack line
- Scrabbled off every loose old-component on recurrence crack line, and patch back with appropriate component
- Emphasis on surface treatment & preparation before apply UROFIBRE, use conjunctionally with UROPRIME (Crystallisation Agent)

SOLUTIONS FOR CONCRETE SHRINKAGE CRACK LINE
- UROFIBRE method for concrete floor shrinkage crack work conjunctionally with UROMIX Immersion System (UROPRIME) for water leaking issue
- Effective and permanent solution for terminating water leaking issues on concrete shrinkage crack
- Apply UROFIBRE on the surface of concrete shrinkage crack with necessary surface preparation, then proceed with application of waterproofing membrane

MIXING

URO FIBRE GLUE
Ready to use from opened cap, do not dilute with water, do not add any admixture, apply with brush.

APPLICATION

SOLUTIONS FOR SURFACE CRACKLINE
- Clean and remove the loosen debris and/or peeled paint from the surface crack line
- Apply UROPRIME for crystallisation the powdery surface and to make clean of the surface
- If the crack line’s void is more than 3 mm, fill up the crack line’s void with skim coat.
- Apply URO FIBRE GLUE with brush, immediately apply UROFIBRE, and brush on again URO FIBRE GLUE until UROFIBRE is wet enough for bonding.
- Remove excessive URO FIBRE GLUE prevent visible ‘ramp’ for following skim coat covering surface
- Leave it to dry for at least 1 hour before the application of skim coat and painting.

LIMITATIONS

- Do not apply to crack line from different building foundation joint.
- Do not apply to crack line from building settlement.

CLEANING

Wash and clean with water when URO FIBRE GLUE is still wet.

HEALTH & SAFETY

This product is non-toxic. In cases of allergic and sensitive skin contact, flush and clean with water. If severe medical reaction happened please seek for professional help.

TECHNICAL DATA (UROFIBRE ADHESIVE)

UROFIBRE

WIDTH	35mm
ROLL LENGTH	4870mm / 487m / 1600ft
WEIGHT	±30 g/m²

UROFIBRE GLUE

PACKAGING	5 Litre /Pail
COLOUR	Milky White
TOOL	Brush
COVERAGE PROPORTIONAL	Urofibre : Urofibre Adhesive : Uroprime 1 roll : 2 pails of 5 Litre : 2 pails of 5 Litre (Subject to method of application, type, temperature, texture and porosity of substrate)
CURING TIME	Approximately 60 minutes (Subject to humidity and temperature)
SHELF LIFE	12 months
STORAGE	Normal, dry conditions at ambient temperature. Store out of direct sunlight.
STORAGE TEMPERATURE	10°C - 37°C

The information provided on this data sheet is not intended to be complete and is provided as general advice only. It is the user’s responsibility to ensure that the product is suitable for its intended purpose. As we have no control over the treatment of the product, the standard of surface preparation, or other factors, we are not responsible for any damages or injury, including but not limited to special or consequential damages which may result from the use of our products, which includes any damages or injury caused by any failure of performance. The information contained in this data sheet may be modified by us from time to time, without any notice arising from our continuous product development activities.